Alarm Display - Sony LH61 Bedienungsanleitung

9. Alarm Display

When any one of the displays described below appears, reset and perform the operation from the
beginning.
Display
Scale disconnected
Excess speed
Overflow
Power failure
Flashes
Error in stored data
Note
When an error in the stored data is shown by "
axis is cleared. In addition, the machine setting contents may also be cleared.
In these cases, perform the following machine settings, and then make the settings again
according to "5-1. Initial Settings" (page 11).
Operating procedure
C L
RESET
P
When using the LH61-3
RESET
When using the LH61-2
6 1 2 P
RESET
Trouble
When the scale is not connected:
Turn the power off, connect the scale, and turn the power back on again.
The display will be reset to "0".
When the scale movement exceeds the maximum response speed of the display
unit. (This alarm also functions when the machine receives a great shock.)
When the display overflows, "F" is indicated in the most significant digit.
When the power fails momentarily during measurement.
When the stored data has been changed by noise, etc.
Turn on the power while holding down the X-
axis key and the 1/2 key.
RESET
Press the Preset key.
Press the key.
RESET
Press keys and the Preset key.
6 1 2
Press the key.
RESET
Causes
" flashing on the display, all the data for that
Display
All digits light up
73