Inputting And Outputting The Program Via The Rs232C - Sony LH61 Bedienungsanleitung

5-14-7. Inputting and outputting the program via the RS232C

Set and confirm the program transfer mode
P
Set the data format
X
0
Set input or output
Y
0
58
Program data can be exchanged via the RS232C if a personal computer or our company's NF12
(discontinued) is used. This allows you to send and store prepared programs in a personal
computer and the NF12 and to receive and execute programs created on a personal computer.
Note
The communication format should be selected in the initial settings. Program input/output is not
possible if the RS232C is in P30 mode. See "8. RS232C Input and Output" for connection details,
including the connector pin configuration.
Select the program input/edit mode.
Operating Procedure
Press the Preset key.
Perform this operation while the program.
Press the Cancel key, and the program
transfer mode is canceled.
This key can be pressed at any time other
than during communication.
(The program input/edit mode is returned
to.)
Select the X-axis.
S w i t c h t h e d a t a f o r m a t w i t h t h e
and keys.
0
Normal ⇔ NF12
Select the Y-axis.
Switch between input and output with the
and keys.
0
OUT ⇔ IN
Display
X
Y
X
INC
mm
Y
INC
mm
X
Y
X
Y
X
Y
X
Y
BH PRG REF
Lights up
BH PRG REF
Lights up
BH PRG REF
Lights up
BH PRG REF
Lights up
BH PRG REF
Lights up
BH PRG REF
BH
Lights up