Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Cautions On Operation; Initial Settings - Sony LH61 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5. Operation

! ! ! ! !

Cautions on Operation

1) When a malfunction occurs, characters as shown in "9. Alarm Display" on page 73 are
2) If two or more operation keys are pressed simultaneously, a malfunction may be caused.
3) Make sure that the least significant digit of an entered value agrees with the selected resolution.

5-1. Initial Settings

Before staring the operation, make the following initial settings:
• Skip unnecessary initial settings by pressing an Axis selector key, and proceed to the next setting.
• After all the initial settings are completed, press the
• By pressing the
• The initial settings, once made, are stored even if the power is turned off. Therefore the initial
To set the initial setting mode
Hold down the X-axis
key and turn the power switch ON.
RESET
1
RESET
Hold down
X
Unless otherwise specified, the following descriptions apply to all axes. Therefore, only the
settings for the first axis are described.
Set the second and third axes in the same manner.
When the type of scale axis changes, this mode is forcibly selected without pressing an axis
selector key.
displayed in place of numerals.When the alarm display appears, press the
relevant axis and repeat the operation.
5-1-1. Setting the resolution and polarity
5-1-2. Setting resolution
5-1-3. Setting linear campensation
5-1-4. Setting the scaling
5-1-5. Setting offset value ∆Y
5-1-7. Setting of touch sensor radius
5-1-8. RS232C setting
5-1-9. Setting inch/mm switching
the power was turned off is displayed, and the unit is switched to the measurement mode.
key at any time during initial setting, the value that was displayed before
RESET
the power was turned off is displayed, and the unit is switched to the measurement mode.
settings are necessary only when the system is newly installed or when any setting revision is
required.
2
Power switch
OFF
ON
Note
key. The value that was displayed before
RESET
The resolution set for each axis will be displayed.
key for the
RESET
11

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis