5-1-6. Absolute zero point clear control
18
• This control becomes necessary when the scale with built-in absolute zero point is replaced or
reinstalled. This control is usually not necessary when using the unit for the first time.
• When the scale with built-in absolute zero point is replaced, be sure to perform the following
controls in the setting mode as described in 5-1-5.
Operating Procedure
To set the absolute zero point offset amount
setting mode, press the Cancel key.
Setting completed.
Note
REF flashes during absolute zero point clearance processing. When the processing ends, REF
lights steadily.
Display
(Displayed for approx. 2 seconds)
mm
REF
Flashes
REF
Lights up