Setting Linear Compensation - Sony LH61 Bedienungsanleitung

5-1-3. Setting linear compensation

• After completing 5-1-2, press the Axis selector key for the Linear compensation setting mode.
• Number keys and
• Select the linear compensation amount per meter as shown below.
• For details, refer to "6. Linear Compensation."
Example : Input to the first axis
Operating Procedure
Example: To set the compensation amount for the first axis to –0.015 mm
X
0 1 5
P
The setting cannot be performed if a number key other than those specified for the linear
compensation is pressed.
key are used to choose one of the linear compensation amounts below.
P
The lower 3 digits of the compensation amount to be set are displayed.
256 different linear compensations (per meter/inch) are available for selection: ±0.001 mm/
±0.000001", ±0.002 mm/±0.000002", ±0.003 mm/±0.000003", ±0.004 mm/±0.000004", ±0.005
mm/±0.000005", ±0.006 mm/±0.000006", ±0.007 mm/±0.000007", ±0.008 mm/±0.000008,
±0.009 mm/±0.000009", ±0.010mm/±0.000010", ±0.015 mm/±0.000015" (in 0.005 mm/
±0.000005 steps) up to ±0.600 mm/±0.000600"
The unit is delivered without compensation set ("LC 000").
Select the input to the first axis.
Note
Press the number keys.
Press the key.
Press the Preset key to complete the setting.
Note
Display
15