Rs232C Setting - Sony LH61 Bedienungsanleitung

5-1-8. RS232C setting

Communication mode setting
X
0
X
0
20
After completing the settings in 5-1-7, press the Axis selector key again to select the setting mode
for the RS232C.
Note
The RS232C only sets the first axis.
Data processing capability (output data when R command is received)
Computer transmission mode : Up to approx. 5.5 data/sec.
Printer mode
(These values apply when the transmission settings are 9600 bps, no parity, 1 stop bit, and
data length of 8 bits.)
• Printer mode is the mode for our company's P30 printer (discontinued) and P40 printer. In this
mode, the output data format is converted to a data format for statistical processing by the
printer. (See the next page.)
The output data is for the X-axis only. In the P30 printer, a delay time is needed for
communication. Set the delay time setting to ON. The communication speed, parity, and other
settings are made automatically. (Communication speed: 2400 dps, no parity, stop bits: 1, data
length: 8) In the P40 printer, no delay time is needed for communication. Therefore, set the
delay time setting to OFF. Also, program input/output is not possible in printer mode. If program
input/output is to be performed, COMP mode should be set.
• If there is no delay time in COMP mode or printer mode, the following communications speed
and other settings must be made.
• The following settings cannot be made when there is a delay time in printer mode. The unit
returns to the initial setting item (setting resolution).
Operating Procedure
Select the X-axis.
Press the and
0
communication mode.
Prnt ⇔ COMP
Select the X-axis when printer mode is
displayed.
Press the and
0
communication mode.
This switches the delay time setting on or off.
ON ⇔ OFF
: Up to approx. 7.6 data/sec.
(Computer communication mode)
keys to switch the
(Printer mode)
(No delay time)
keys to switch the
(A delay time is used. This is for the P30.)
Display