Sharp PG-MB60X Service Anleitung Seite 31

No. Adjusting point
29 USB operation
check
30 Delivery set-
tings
Calling and quitting the process mode with the control keys on this model.
∗ Although it is possible for the process OUT to exit using the process menu, the IN/OUT toggle command is also
available considering the existing specification.
1. Calling and quitting
With the menu not displayed, press the "ENTER", "ENTER", "VOL+", "VOL-", "ENTER", "ENTER" and "MENU"
keys on main unit.
2. Others
Press the S3563 process key (toggle) on the main PWB to call and quit the process menu.
Note: When adjusting in the process mode, set a signal with a vertical frequency of 60 Hz or no signal. (May not be
properly adjusted with other signals.)
Resetting the lamp timer for this model
1. Resetting procedure
In Stand-by, run this command to clear the operating time of the lamp to 0 and turn on the power.
Press and hold "DOWN", "ENTER", and "MENU", and then press the "ON" key of the set.
Forced disabling of the System-Lock of this model
1. Disabling procedure
With System-Lock input window onscreen, press the "MENU", "ENTER", "ENTER", "MENU", "ENTER", "ENTER"
and "MENU" keys of the set.
Adjusting conditions
1. Connect to a PC with a
USB cable.
Adjusting procedure
1. Check that advance/reverse operation on PC screen
is possible by using remote control.
1. Make the following settings.
Destination Process
adjustment
USA
China
Europe and
the Other
Contries
31
PG-MB60X
Remote control
adjustment
SS4 Factory setting at 4
SS6 Factory setting at 6
SS3 Factory setting at 3