Sharp PG-MB60X Service Anleitung Seite 19

3. Attaching the top body (For the screws to apply, refer back to "2. Removing
the top body".)
3-1. Insert a postcard or such thick paper upper surface the lens barrel.
3-2. Place the top body in position. Make sure the four hooks are tightly caught.
3-3. Draw out the postcard.
Top Body
3-2
Bottom Body
3-1
Thick paper such as postcard
4. Removing the main PWB unit and the peripheral units
4-1. Remove 2 main PWB fixing screws (terminal side).
4-2. Remove 8 main PWB fixing screws.
4-3. Remove 12 connectors from the main PWB.
4-4. Pull out the switch bracket connector and remove 3 fixing screws. Remove 1 fixing screw and detach the bi
metal unit.
4-5. Remove the fixing screw for the front R/C PWB.
4-6. Remove 2 fixing screws for the A/F holder unit.
4-7. Lift off the main PWB in an oblique direction from the optical mechanism unit side.
4-8. Remove the speaker holder ass'y.
4-9. Remove 2 fixing screws and remove the ballast output socket.
Switch Bracket Unit
Front R/C PWB
A/F Holder unit
4-4
4-3
Bi Metal Unit
[RA]
[FC]
[FA]
[FB]
4-4
[TO]
[TF]
[DD]
[CW] [FD]
4-9
[AZ]
4-5
4-6
19
Main PWB Unit
Earth Lead Wire
4-2
[EA]
[SO]
4-7
4-1
4-8
Speaker
Holder
Ass'y
PG-MB60X
3-3