Troubleshooting And User Messages - Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung

9. Troubleshooting
9.1 General Error Codes
The unit continuously monitors its operation. It produces error codes to assist you in running it smoothly.
A sticker containing the most common error codes is provided in the box. You can place it on the mower for your
convenience.
E9* (See Troubleshooting in Manual) represents stops
and error that are not very common, and thus they
are not shown in the above Error Code Table. If E9
is displayed, press the RIGHT arrow to receive the
Error Code reason, for which the mower has stopped
and refer to the User Manual for more details.
• Usually, if the mower stops, an error code is
displayed. This display stays on for 5 minutes. If you
arrive later than those 5 minutes, the display will be
blank.
• To wake the unit up and see the last error code
displayed prior to stopping, press the OK button on
the mower.
The following table displays all Error Codes and gives possible causes and corrective actions:
E1
Stuck in
Place
The
E 2
mower is
Outside
Capitolo 3 - Funzionamento e ricarica
78
and User Messages
The unit got stuck in place. It cannot
continue driving.
Drive wheel motors have been
working under a severe load.
The unit has difficulty turning in
place because the front wheel is
blocked by a ditch or non-level
ground.
The Perimeter Wire is too close to
the edge of the lawn.
The Perimeter Wire has been laid the
wrong way around a perimeter
island.
The lawn slope is too steep along the
edge.
The unit does not succeed to turn in
place at the edge and it I causing the
mower to slip out of the designated
area.
Automatic operation is initiated
while the robot is placed out of the
Perimeter Wire loop.
Unit Error Codes Table
E 1
Stuck in Place
E 2
The mower is Outside
E 3
No Wire Signal
E 4
Check Power
E 5
Check Blade / Cutting Height
E 6
Check Drive
E 7
Front Wheel problem
E 8
Decrease Inactive Time
E 9*
See Troubleshooting in Manual
Remove the mower away from this particular location and restart
operation.
Rectify the reason for it getting stuck.
Check the ground around the mower for ditches or non-level
ground. Fill with dirt and level off.
Check if the drive wheels are free to rotate and nothing is
blocking them.
Verify that the cutting height is not set too low for the grass
condition - increase the cutting height if needed.
Check that the Perimeter Wire is not too close to the edge -
remove the wire towards the inner side of the lawn.
Confirm that the Perimeter Wire has been laid according to the
instructions in the Manual.
Do not include areas with very steep slopes.
Verify that the cutting height is not set too low - Increase the
cutting height.
Place the mower inside the lawn and renew the operation.
en