Maintenance; Faults And How To Remedy - Wolf Garten 2.46 HA Gebrauchsanweisung

Operation
Emptying of Grassbox
The grassbox is full and should be emptied as soon as grass clippings remain uncollected on the ground behind your mower.
Fixing of handle
TTENTION! Take care that the switch cable does not become caught and crused when fol-ding the handle frame (fig. M1/M2/M3).

Maintenance

Disconnect spark plug cap and starter key before proceeding (fig. W1/W2)
Clean mower thoroughly after each mowing with cloth or brush. Do not spray with water. Keep mower in a dry room.
Change oil only
While engine is warm and fuel tank empty.
Change oil after the first 5 working hours. Thereafter chane engine oil every 25 working hours and at the end of the mowing season.
Change engine oil more frequently if working under extreme and dusty conditions. To drain the engine oil, remove oil filler cap, tilt
machine slowly to side and allow oil to drain from the crankcase through the filler.
Cleaning of Spark Plug
Check and clean regularly, reset plug gap as required (0,70 mm).
Cleaning of air filter
Refer to the engine manufacturer's handbook supplied.
Cleaning operations and blade change (fig. W1)
When cleaning the mower and changing blades, lay the mower on its right hand side as illustrated. Pull off the spark plug lead.
Sharpening and changing blade (fig. W3)
Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.
Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on
the blade. Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm.
djusting the clutch Bowden cable (Fig. W4/B7)
Lift the drive bar B7 (5) approx. 2 cm and hold. Loosen counternut W4 ( ) and turn adjusting screw W4 (B) anticlockwise until the drive
wheels block when the mower is pulled backwards. Tighten counternut W4 ( ) firmly.
Winter storage
• Drain fuel tank.
• Drain carburettor
- therefore start engine, keep it runninug until it automaticalli switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug
- Poor one spoon full of engine oil into spark plug hole
- Pull starter rope slowly to distribute oil evenly inside cylinder
- Replace spark plug but do not connect spark plug lead
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once a year by approved Service gent.

Faults and how to remedy

Problem
Motor does not start or
has no power:
Uneven cutting:
Drive does not start:
When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark
plug lead before inspecting, cleaning or working on the blades.
Possible cause
• Insufficient fuel in the tank
• Spark plug lead not connected
• Spark plug out of order
• ir filter dirty or oily
• Throttle lever not at „Run"
• Blade fastening screw loose
• Clutch linings worn
• Cutting height misadjusted
• Blunt blades
• ir / duct catcher bag blocked
• Clutch Bowden cable misadjusted
WOLF
service
workshop
---
---
---
---
---
X
X
---
X
---
---
11
Remedy (X) by:
Yourself
X
X
X
X
X
---
---
X
---
X
X