Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 66

• Start laying the wire in anticlockwise direction.
• Once completing the Perimeter Wire loop, lay the wire back
towards the Perimeter Switch.
• At the end of the Perimeter Wire loop, you have now two wires.
Lay the two loose wires in the direction of the Perimeter Switch
location and peg them to the ground using a single peg for both.
4.8.4 At the Perimeter Switch's location:
•
Trim the ends of the loose wire to equal length and twist them
together.
•
Strip 5mm (0.2 inches) of insulation from the wire without the
plot connector.
•
Insert this wire end into the free hole in the connector and
tighten the screws.
•
Plug the perimeter wire connector into the Perimeter Switch.
66
en