Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 80

9.2 Detailed Error Codes
If the above table (Section 9.1) does not give enough information to help solve the problem, then press the RIGHT arrow
while the error code is displayed in order to receive a number that gives more details about the problem and refer to the table
below:
0010
Mow
Overheat
0011
Drive Overheat
0012
No wire signal
0014
Front wheel
problem
0015
Button pressed
0016
Low
temperature
0020
Rain detected
0021
Check mowing
height
0022
Check mowing
motor
0023
Check power
0026
Base problem
0027
Start Elsewhere
0028
Cross Outside
80
The mowing motor has been working under a
severe load for too long.
The drive motors have been working under a
severe load for too long
See E3 in the above table
See E7 in the above table
One of the operating panel buttons is constantly
pressed.
Mower does not depart automatically from the
Base Station when the ambiance temperature is
lower than 5ºC (41ºF).
Information - When the temperature is below 5ºC
(41ºF) the grass does not grow or grows very
slowly.
However Manual Depart is enabled
The operation is delayed as the unit detects rain.
Mowing motor has faced over-current
conditions for too long as a result of high grass
or an obstacle that is stuck or wrapped around the
blade.
Something is preventing a blade from rotating
freely.
Severe grass accumulation under the mowing
deck, rope, or similar object is wrapped around
mowing blade.
Mowing motor has faced over-current for too
long in the Base Station before starting the
operation.
See E4 in the above table
The unit fails to enter the Base Station several
consecutive times.
Drive wheel motors have been working under
severe load during automatic or manual
operation
The Perimeter Wire is too close to the edge.
The lawn slope is too big.
The unit does not succeed to turn in place at the
edge and it causes the mower to slip out of the
designated area.
The unit has slipped out of the Perimeter Wire
lope because of sloping area or wet grass.
No need for action – the unit will renew automatically
the operation after the mowing motor will cool down.
No need to do anything.
The unit will renew the operation automatically as
soon as the drive motor will cool down.
Press 'OK' to confirm the message and continue
operation. This message is displayed to inform only
No need to do anything.
The unit will renew the operation automatically as
soon as the ambiance temperature will rise above 5ºC
(41ºF).
No need for action.
The message is displayed until the unit will not detect
rain and then will start mowing
CAUTION – Switch Off the Safety Switch before
checking the blade.
Inspect the blade for foreign material or debris
preventing rotation.
Clean out accumulated grass clippings using a wooden
stick.
CAUTION – Switch Off the Safety Switch before
checking the blade.
Remove the mower from the Base Station. Inspect the
blade for foreign material or debris preventing rotation
Adjust the Base Station position.
Clean the contacts with a brush or piece of cloth.
Check to insure the mower is not stuck, causing the
drive wheels to slip.
Check the ground around the mower for holes or
indentations. Fill with dirt and level off.
Check if the drive wheels are free to rotate and nothing
is blocking them.
Remove the mower away from this particular location
and restart operation
Remove the wire towards the inner part of the lawn.
Do not include this area because of its steep slopes.
Fill holes and pits in the ground.
Increase the cutting height
en