Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 55

3.3 Select Base Station Location
3.3.1 Base Station Location Guidelines
Do not
place
3 meters (10 ft.) after a corner (relevant for Internal
setup only (section 3.3.2).
The Base Station should be within 15m (50 ft.) of a
power outlet (230V / 120V).
If the lawn has more than one zone, place the Base
Station within the largest zone.
Make the Base Station invisible to the street to avoid
theft.
Select a shady spot. This will extend battery lifetime.
Place the Base Station on a relatively level ground. Do
not place it on a slope.
Place the Base Station away from sprinkler heads.
There are two options to set the Base Station:
3.3.2 Internal Setup (on the lawn perimeter)
Choose a place along the Perimeter Wire where you
want to place the Base Station, based on the inputs
given in paragraph 3.3.1.
Place the Base Station in the direction shown in the
figure to the right.
3.3.3 External Setup (off the lawn perimeter): At a
corner
In this type of setup, the Base Station is located at one of
the corners of the lawn, as shown in the figure at the right.
Choose a corner where you want to place the Base
Station outside of the lawn area.
Place the Base Station, where its front side is touching the
lawn edge or placed somewhat on the lawn.
Continue to lay the perimeter wire as shown in the figure
to the right, where it continues at least 10cm beyond the
Base Station and turns back towards the lawn at a distance
of 10cm from the other wire.
The Base Station may be placed in a small shift to the
right in order to allow smooth entry of the mower to the
Base Station.
You will have the opportunity to later adjust the Base
Station position to confirm smooth entry.
Capitolo 1 - Installazione del fi lo perimetrale
en
the Base Station within
55