Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 61

4.3 Perimeter Wire within the Working Area
4.3.1 Hard Obstacles
o
Obstacles that can withstand a collision, for example, trees or bushes higher
than 15 cm, do not need to be demarcated by the Perimeter Wire. The unit
will turn when it collides with this type of obstacle.
4.3.2 Perimeter Islands
o
Use the Perimeter Wire to demarcate areas inside the working area by creating islands around obstacles that cannot
withstand a collision, for example, flower beds and fountains.
o
Continue uncoiling the wire, moving from the edge towards the protected object.
o
Peg the Perimeter Wire around the protected object in a clockwise direction.
o
Complete bordering the island and return to the spot where you left the lawn's edge
o
The wires leading to the Island and from it should be parallel and touching.
Therefore, peg both wires, to and from the island, together with the same pegs.
o
The unit will not recognize these two wires. It will mow over them as if they do not exist.
o
The unit will recognize the single blocking wire around the Perimeter Island and will not enter this area.
Keep the following distances when setting Perimeter Islands:
-
The minimum distance of the Perimeter Wire from the
protected area should be 28 cm (11 inches).
-
If you need to protect a thin object, set the minimum
radius of the Island to 35 cm (15 inches).
-
Maintain a minimum of 1m (3.3 ft.) between adjacent
islands.
-
Maintain a minimum of 1m (3.3 ft.) between island wire
and the Perimeter Wire.
-
If protected objects are grouped closely together,
demarcate them as a single Perimeter Island.
en
CAUTION ! Setting the Perimeter Wire anticlockwise around the obstacle
will cause the mower to drive into the island.
61