Faults And How To Remedy; Guarantee Terms - Wolf Garten TC 32 ME Gebrauchsanweisung

Maintenance
Disconnect from power supply before performing
maintenance and cleaning.
Clean mower thoroughly after each mowing with cloth or
Please note: the air intake slots of the electric
brush.
motor must be freed from grass and moss accumulations
(M4, 1)!
Do not spray machine with water. Store machine in a
dry room.
djusting the lower blade (Fig. W1)
You must readjust the blade if the mower no longer cuts the
lawn uniformly and cleanly.
Caution: Wear protective gloves.
Turn over the mower as illustrated.
tightening the two lock nuts (1) on the botton blade (2).
Required tools: Spanner (wrench) 10 mm F.
Turn the lock nut (1) to the left:
The clearance to the blade cylinder (3) decreases.
Turn the lock nut (1) to the right:
The clearance to the blade cylinder (3) increases. djust the
lower blade in such a manner that all cutting edges of the
blade cylinder touch lightly.

Faults and how to remedy

Problem
Motor will not run
In case of unsteadiness or
heavy vibration
Poor mowing
Blade spindle does not
rotate
When in doubt, always consult a WOLF service workshop.
Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.

Guarantee terms

Please carefully retain the guarantee card completed by the
seller, or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months
from the date of purchase. This guarantee is in accordance with
the relevant state of technology and the utilisation purpose / area
of application. The consumer's statutory rights are not affected by
the following guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial
sector or leasing business.
- Proper handling and observance of all information given in the
operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
10
djust by loosening or
Possible cause
• Fuse blown
• Overload/blocking
(Safety switch has shut mower off)
• Cable damaged
Important! If you inadvertently cut through the cable,
the fuse (10 mp.) will not always blow. In the interest
of safety, never touch damaged or servered cables be-
fore disconnecting the mains plug. Repairing the cable
with insulating tape is prohibited.
• Blades are damaged
• Bottom blade is set incorrectly
• Blades are dull
• Incorrect cutting height
• Lower blade dull
• Blades are blocked (grass, branches, etc.)
• Toothed belt is damaged
Cutting test with paper (Fig. W2)
Caution: Wear protective gloves.
The adjustment is correct if a piece of paper between the
blade spindle and the lower blade is cut cleanly. To do
this turn the blade cylinder by hand.Note:
If problem-free cutting results are not obtained, in spite of
adjustment as prescribed, then the blade spindle, and/or the
bottom blade must be checked (see maintenance).
Changing blades (Fig. W3)
Caution: Wear protective gloves.
Change worn blades only as a set (15 blades)
15 replacement blades TC-M, part no.: 3628 094
New blade condition „Mach 15"
1. djust bottom blade (W1).
2. Conduct cutting test with paper (W2).
ll other repairs must be performed by a WOLF service
center.
WOLF
service-workshop
---
---
X
---
---
---
---
X
---
X
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of
purchase.
This guarantee does not extend to normal wear-and-tear on
blades, blade mounting components or friction disks, V-belts/
toothed belts, running wheels/tyres, air filters, spark plugs and
spark plug connectors. ny guarantee claim shall be immediately
void in the event of unauthorised repairs. Faults and defects which
can be traced to material or manufacturing faults will be rectified
exclusively by our contracted workshops (the seller has the right to
remedy a defect) in your vicinity, or by the manufacturer if the latter
is closer. ny claims going beyond the provision of a guarantee are
ruled out. There is no entitlement to a replacement. ny transport
damage should be reported not to us but to the shipper in question
since, otherwise, any compensation claims vis-à-vis the shipper
would be voided.
Remedy (X) by:
Yourself
X
X
---
X
X
X
X
---
X
---