Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 79

E 3
No Wire Signal
E 4
Check power
E 5
Check Blade /
Cutting Height
E 6
Check Drive
E 7
Front Wheel
Problem
E 8
Decrease
Inactive Time
See
E 9
Troubleshooting
in Manual
en
Power Box/Perimeter Switch is not
turned on or not connected
The Perimeter Wire is not
connected to the Base
Station/Perimeter Switch.
The Perimeter Wire is cut.
Power Box is not plugged in
properly into the power outlet.
No power at the power outlet or the
main power is shut off.
The mower or Base Station
contacts are dirty.
Charging is not detected, although
there is a physical contact between
the mower and the Base Station
contacts.
Mowing motor has faced over-
current conditions for too long as a
result of high grass or an obstacle
that is stuck or wrapped around the
blade.
Something is preventing a blade
from rotating freely (Accumulated
grass clippings under the mowing
deck; rope or similar object
wrapped around mowing blade).
Grass or other object has wrapped
around the drive wheel.
The drive motors have been
working under severe load for too
long.
The Front Wheel has left the
ground for too long during
operation
Too many Inactive Days and/or
Hours have been set for your lawn
area.
E 9 is displayed for all other
messages that are not listed in the
above table.
Make sure the Base Station is connected to the mains supply.
Disconnect the Power Box from the mains power and
reconnect after 10 seconds.
Check that the low voltage cable between the Power Box and
the Base Station is connected.
Check the LED indications on the Power Box.
Check the connection of the Perimeter Wire to the Base
Station / Perimeter Switch.
Check the installation for cut wire. Repair broken cable with
the waterproofed connector supplied in the box.
Confirm Power Box is plugged into the power outlet.
Turn power on to the power outlet.
Check the power outlet using another appliance.
Clean the contacts with a brush or piece of cloth.
Confirm a good connection of the Power Box to the Base
Station.
Switch off the Safety Switch before checking the
blade.
Inspect blade for foreign material or debris preventing
rotation.
Clean out accumulated grass clippings using a wooden stick.
Check the drive wheels and remove the grass or other
objects.
If the unit has driven onto an obstacle, Switch off the Safety
Switch, raising the front end: Remove or exclude the object
from the mowing area.
If the unit is being used on a slope too steep for safe mowing,
exclude this from the mowing area.
If high grass is preventing the front wheel from fully turning
on the ground, raise the cutting height.
If the ground contains large holes or indentations where the
front wheel can drop into when passing across, fill these
areas with dirt and level off.
Decrease the number of Inactive Days and/or the number of
Inactive Hours to allow the unit to complete mowing your
lawn.
Press the 'Right arrow' button to receive the stop reason
number and refer to the next table for more details about the
stop reason, causes, and actions.
79