Herunterladen Inhalt Inhalt Diese Seite drucken

Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 62

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
4.3.3 Setting a Narrow Pass
If the Narrow Pass is wider than 2m, and you want the unit to mow the area inside the Narrow Pass, then you can set the
wire as shown in the figure below. Such a setup allows the mower to mow inside the Narrow Pass while mowing the inner
part of the lawn, but prevents it from crossing between the zones.
A. At the point you want the mower to
start driving towards the Sub-Zone
start to set the Narrow Pass.
B. Set an Island at the middle of the
Narrow Pass and keep
of 10 cm (4 inches) from the Perimeter
Wire.
C. The island dimensions should be 30
cm along the side and as wide as
needed, keeping 10 cm from both
sides.
D. After completing the setup of the
wire in the Sub-Zone, make sure
you keep 10 cm (4 inches) between the
wire and the island on the way back to
the Main Zone.
4.4 Fastening Perimeter Wire to the Ground
o Before starting to lay the Perimeter Wire, it is recommended to cut the grass where the wire is to be laid. It will
then be easier to attach the wire to the ground. The risk that the mower will damage the wire during the operation
is reduced.
o It is not necessary to bury the Perimeter Wire, though you may do so, up to 5 cm (2 inches) deep.
o Pull the wire tight while hammering the peg all the way into the ground.
WARNING !
Protect your eyes! Protect your hands!
Use proper eye protection and wear appropriate work gloves when hammering the pegs.
Hard or dry ground may cause pegs to break when driving them in.
o Use a hammer to insert the pegs into the ground.
o Insert the pegs at distances that will keep the wire down
below the grass level and prevent the wire from becoming
a tripping hazard (approximately 75 cm between pegs).
• The wire and the pegs will gradually become invisible
under the growth of new grass.
o If an additional wire is required in order to complete the
setup, connect it using the water-proof wire connectors
supplied with the unit. (See Section 11.4 – Splicing the
Perimeter Wire).
62
a distance
en

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis