Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 63

Use only the wire connectors supplied with the unit.
Neither Twisted cables, nor a screw terminal insulated with
insulation tape are a satisfactory splice.
Soil moisture will cause the conductors to oxidize, which will
later cause a broken circuit.
4.5 Back at the Base Station – Completing the Perimeter Wire Setup
Once the Perimeter Wire loop is completed and pegged to the
ground, complete the setup by attaching the beginning and the end of
the Perimeter Wire to the Base Station Head.
o Hold both ends of the Perimeter Wire: the wire that started the
loop is the one with an attached connector.
o Twist the two wires.
o Trim the end without the connector to make both of equal length.
Remove any excess wire and strip back 5 mm (1/4 inches) of
insulation from the wire end.
o Peg the two Perimeter Wires down to the ground using the same
peg leaving enough loose wire. Twist together the two loose
parts.
o Insert the end of the wire without the connector into the
hole of the connector. Use a small flat screwdriver to
tighten and secure this wire into the connector.
4.6 Placement and connection of the Base Station
o
Place the Base Station on the Perimeter Wire as shown in
the figure to the right.
o
Align the center of the Base Station on the wire.
o
Attach the Perimeter Wire connector to the Base Station
Head
en
63