Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 69

5.3.3 Main Zone Area
• Scroll to select an approximate area (EU- m² / US- ft²) of the
Main Zone, where the Base Station is installed.
If an additional zone (Separated Zone) exists, do not include
it in this area (it will be set separately) .
Note – It is necessary to complete the above settings (5.2.1 – 5.2.3)
in order to operate the mower. Every press on the STOP
button will change the screen one step back in the process.
5.3.4 Test Base Station Position
• After setting the area,
displayed.
• Place the unit inside the lawn, approximately 3 m (10 ft.) in
front of the Base Station, facing the Perimeter Wire and press
OK to start the test.
• The unit drives towards the Base Station:
If the mower does not start the test, then one of the
following messages will be displayed:
E3
is connected to the power outlet and that the
Extension Cable is connected at both ends, from the
Power Box to the Base Station.
U029
Perimeter Wire has been connected in the opposite
direction. Swap the wires at the plot connector.
• The unit will enter the Base Station, drive back, wait in front
of the Base Station, and display
U051
If
displayed:
• Move the Base Station slightly to align it with
the Perimeter Wire.
•
heck for any obstacles that may interfere with
the mower's entrance to the Base Station
• While U002'
Stakes of the Base Station to secure it to the ground and press
OK.
en
U001
(Test Base Station Position) is
Confirm that the Power Box
U002
).
message is
is displayed, insert the remaining
The
69