Wolf Garten Ambition Robo Scooter 300 Betriebsanleitung Seite 85

To remove the blade:
-
Insert the clamp side of the Blade Removal Tool into the
open slits beside the locking tabs on either side of the
blade.
-
Turn the Blade Removal Tool slightly so that the clamp
resides on top of the locking tabs on either side.
-
Squeeze the handle of the Blade Removal Tool. The
locking tabs on each side of the blade will be pressed (1).
-
Pull the blade assembly off, away from the mower (2)
-
When reinstalling the blade, line up the mating splines and
push until a firm click is heard, indicating a proper seating of
the blade onto the shaft.
11.3 Disposing of the Old Battery Pack
!
IMPORTANT
disposed of in an environmentally sound manner. Return the old power pack to an approved battery recycler.
11.4 Splicing the Perimeter Wire
If the Perimeter Wire needs to be spliced, use the connectors supplied in the unit box. It is waterproof and gives a
reliable electrical connection.
!
IMPORTANT
1. Strip 1 cm (0.5 inch) of each wire end together and twist the
stripped ends using pliers.
2. Insert the twisted wires into the splicing connector.
3. Screw the wire connector on the twisted wires. Make sure it is
tightly secured.
!
IMPORTANT
insulated with insulation tape are a satisfactory splice. Soil moisture
will cause such conductors to oxidize and will later lead to a broken
circuit.
11.5 Maintenance of the Base Station Area
• Keep the Base Station entrance and area clean of leaves, sticks, twigs or any other debris that usually accumulate
in such areas.
• NEVER spray a water hose directly towards the Base Station.
• Be careful when trimming around the Base Station with a powered weed trimmer as damage to the Extension
Cable may occur.
• In the event of damage to any part of the Extension Cable, stop the use of the mower and the Base Station.
Disconnect the Extension Cable and replace it.
en
!
Do not place used batteries in your household trash. The battery must be collected, recycled, or
!
Before slicing the Primeter Wire, disconnect the Power Box from the power outlet.
!
Neither twisted cables, nor a screw terminal
85