Access To Mini-Joystick And Osd Setting; Lens Setting; Ir Led Setting - Santec VTC-262HWD Bedienungsanleitung

Bedienungsanleitung / User manual
VTC-262HWD, VTC-322HWD, VTC-369IRHG, VTC-369IRHW,
VTC-432IRHWD, VTC-279IRHWD, VTC-289IRHWD

7.3 Access to mini-joystick and OSD setting

All camera adjustments are done via an OSD menu using a mini-joystick. Access the mini-
joystick as follows (see picture 2):
At the bottom of the camera there is a small lid. Open the lid carefully by turning it left using
the supplied opener. Below the lid you will find a mini-joystick for the OSD control, a switch
for adjusting the brightness of the IR-LEDs and an additional video connection for service
purposes (connection is being done by the included adapter). Press onto the joystick and a
menu pops up in the video picture. You can now move the joystick left/right/up/down in order
to get to the desired menu item. For confirming your choice, press onto the joystick.
See chapter 8 for „Camera settings via OSD menu".
Once all settings are made, close the lid again. Please make sure that the rubber gasket is
not damaged.
Finally, clean the front glass to remove fingerprints and other stains.

7.4 Lens setting

Lens adjustment (focal length and focus) is done by the two setting screws F and Z
(see picture 2):
Carefully turn the screws clockwise or counter-clockwise to adjust the lens according to your
needs.
7.5 IR-LED setting
The camera is equipped with IR LEDs. Hence a surveillance even under poor light conditions
and in darkness is possible.
On the camera, there is a control pin to set the IR LEDs.
It is possible to switch off the IR-LED completely so that the camera can also be operated
without IR illumination. If the IR function is enabled, the IR LEDs automatically switch on or
off, depending on the light conditions.
When installing the camera and adjusting the lens, please ensure not to cover the IR LEDs.
Never point the IR LEDs directly to a bright spot (e.g. a white wall) because this might lead to
reflections.
Depending on the light conditions, the integrated IR LEDs automatically switch on and off.
The range of the IR LEDs strongly depends on the site and the environment.
Attention:
The camera is equipped with IR-LEDs. Please make sure to always keep a
distance of > 1m to avoid damages to your health. Never look directly into the
IR-LEDs – this may cause eye damages!
_________________________________________________________________________________
F = Focus; Z = Focal length
- 73 -