General Installation; Power Supply And Monitor Impedance; Connections - Santec VTC-262HWD Bedienungsanleitung

Bedienungsanleitung / User manual
VTC-262HWD, VTC-322HWD, VTC-369IRHG, VTC-369IRHW,
VTC-432IRHWD, VTC-279IRHWD, VTC-289IRHWD

2. General installation

This camera has been designed for video surveillance applications. The appliance must only
be installed by qualified service personnel and has to comply with local specifications and
regulations.
Make sure to fix the camera onto a solid basis (wall or ceiling) which is capable of carrying
the weight of the camera. Ensure that the camera is safely installed by using only suitable
screws.

2.1 Power supply and monitor impedance

Only use a stabilised 12 V DC or 24 V AC power supply unit with sufficient wattage (see
chapter "Technical specifications" for recommended power supply units).
Only approved cables should be used.
If a monitor is connected directly, the monitor impedance has to be 75 Ohm. Verify the
connection in case the video picture is of poor quality.
On the camera, you will find an additional video connection.
A cable adapter BNC socket/plug is included in the delivery which can be put onto the
additional video connection, e.g. to connect a monitor during the camera installation phase in
case the regular cable has already been laid.

2.2 Connections

The following connections/adapters are included in the delivery:
_________________________________________________________________________________
Cable adapter/
screw connector
Cable adapter BNC socket,
e.g. for monitor connection
during installation phase
- 49 -
Video connection
(BNC socket)
Power connection
(DC socket)