Access To Mini-Joystick And Osd Setting; Lens Setting; Ir Led Setting - Santec VTC-262HWD Bedienungsanleitung

6.3 Access to mini-joystick and OSD setting

All camera adjustments are done via an OSD menu using a mini-joystick. Access the mini-
joystick as follows (see pictures 2 and 4):
Loosen the security screw on the housing. Pull off the housing. You will find a mini-joystick
for the OSD control, a switch for adjusting the brightness of the IR-LEDs and an additional
video connection for service purposes (connection is being done by the included adapter).
Press onto the joystick and a menu pops up in the video picture. You can now move the
joystick left/right/up/down in order to get to the desired menu item. For confirming your
choice, press onto the joystick.
See chapter 8 for „Camera settings via OSD menu".
Once all settings are made put the housing back onto the camera and tighten the security
screw carefully.
Finally, clean the camera dome to remove fingerprints and other stains.

6.4 Lens setting

Lens control (focal length and focus) is done by the two setting rings. Carefully loosen the
two safety screws a bit so that you are able to turn the setting rings. Adjust the lens
according to your needs. Finally, seize the two safety screws again carefully.
6.5 IR-LED setting
The dome camera is equipped with IR LEDs. Hence a surveillance even under poor light
conditions and in darkness is possible.
On the camera, there is a control pin to set the IR LEDs.
It is possible to switch off the IR-LED completely so that the camera can also be operated
without IR illumination. If the IR function is enabled, the IR LEDs automatically switch on or
off, depending on the light conditions.
When installing the camera and adjusting the lens, please ensure not to cover the IR LEDs.
Never point the IR LEDs directly to a bright spot (e.g. a white wall) because this might lead to
reflections.
Depending on the light conditions, the integrated IR LEDs automatically switch on and off.
The range of the IR LEDs strongly depends on the site and the environment.
Attention:
The camera is equipped with IR-LEDs. Please make sure to always keep a
distance of > 1m to avoid damages to your health. Never look directly into the
IR-LEDs – this may cause eye damages!
_________________________________________________________________________________
VTC-262HWD, VTC-322HWD, VTC-369IRHG, VTC-369IRHW
VTC-432IRHWD, VTC-279IRHWD, VTC-289IRHWD
- 68 -
Bedienungsanleitung / User manual