Lens Setting - Santec VTC-262HWD Bedienungsanleitung

5.4 Lens setting

1. Loosen the housing ring from the mounting ring only a bit so that the camera ball can
move freely.
Attention:
Don't loosen the housing ring too much to avoid that the camera drops down to the
floor!
2. Turn the camera ball to adjust the lens to the desired position.
3.
Adjust the focus and the zoom.
4. When adjusting the lens, please make sure that – when in the final position – neither
the lens nor the IR LEDs are covered by the housing ring but instead they are
positioned in the cut-out. Please ensure that the IR LEDs are not covered.
5. Once the lens has been set and positioned, tighten the housing ring again to the
mounting ring and secure it with the safety screw.
_________________________________________________________________________________
VTC-262HWD, VTC-322HWD, VTC-369IRHG, VTC-369IRHW
VTC-432IRHWD, VTC-279IRHWD, VTC-289IRHWD
- 62 -
Bedienungsanleitung / User manual