Ir Led Setting - Santec VTC-262HWD Bedienungsanleitung

Bedienungsanleitung / User manual
VTC-262HWD, VTC-322HWD, VTC-369IRHG, VTC-369IRHW,
VTC-432IRHWD, VTC-279IRHWD, VTC-289IRHWD
5.5 IR-LED setting
The dome camera is equipped with IR LEDs. Hence a surveillance even under poor light
conditions and in darkness is possible.
On the camera, there is a control pin to set the IR LEDs.
It is possible to switch off the IR-LED completely so that the camera can also be operated
without IR illumination. If the IR function is enabled, the IR LEDs automatically switch on or
off, depending on the light conditions.
When installing the camera and adjusting the lens, please ensure not to cover the IR LEDs.
Never point the IR LEDs directly to a bright spot (e.g. a white wall) because this might lead to
reflections.
Depending on the light conditions, the integrated IR LEDs automatically switch on and off.
The range of the IR LEDs strongly depends on the site and the environment.
Attention:
The camera is equipped with IR-LEDs. Please make sure to always keep a
distance of > 1m to avoid damages to your health. Never look directly into the
IR-LEDs – this may cause eye damages!
_________________________________________________________________________________
- 63 -