Lens Adjustment - Santec VTC-369IRPW Bedienungsanleitung

1.2 Lens adjustment

1. Loosen the housing ring from the mounting ring only a bit so that the camera ball can
move freely.
Attention:
Don't loosen the housing ring too much to avoid that the camera drops down to the
floor!
2. Turn the camera ball to adjust the lens to the desired position.
360° pan
3.
Adjust the focus and the zoom.
4. When adjusting the lens, please make sure that – when in the final position – neither
the lens nor the IR LEDs are covered by the housing ring but instead they are
positioned in the cut-out.
5. Once the lens has been set and positioned, tighten the housing ring again to the
mounting ring and secure it with the safety screw (also see chapter 1.1).
_________________________________________________________________________________
- 32 -
Bedienungsanleitung / User Manual
VTC-369IRPW, VTC-369IRPG
10° - 90 ° tilt