10. Flow diagram for the programming levels
Power ON
PV/SV display mode
PV
A1 value is
A1 value
displayed.
+
PV
A2 value is
A2 value
displayed.
+
PV
A3 value is
A3 value
displayed.
+
Alarm setting mode
A1 value
A2 value
A3 value
Returns to PV/SV display
mode.
(3 sec)
+
Auxiliary function setting mode 1
Set value lock
Sensor
correction
coefficient
Sensor
correction
Returns to PV/SV display
mode.
[About setting item]
•
A1 value
•
•
[About key operation]
•
+
: Press the
item, illustrated by an arrow.
•
: Press the
key. The unit will move to Alarm setting mode.
•
+
(3 sec): Press and hold the
unit will move to Auxilary function setting mode 1.
•
+
+
(3 sec): Press and hold the
approx.3 sec. The unit will move to Auxiliary function setting mode 2.
•
+
(5 sec): Press and hold the
unit will move to Maintenance mode.
+
Auxiliary function setting mode 2
Input type
Scaling high
limit
Scaling low
limit
Decimal
point place
PV filter time
constant
A1 type
A2 type
A3 type
A1 Energized /
De-energized
A2 Energized /
De-energized
A3 Energized /
De-energized
A1
hysteresis
Upper left: PV Display: Indicates the setting item characters.
Lower left: SV Display: Indicates the factory default. Right side: Setting item
: Available only when option is ordered.
and
key (in that order) together. The unit will move to the next setting
and
key (in that order) together for approx. 3 sec. The
,
and
keys (in that order) together for approx. 5 sec. The
+
(3 sec)
A2 hysteresis
A3 hysteresis
A1 delay
time
A2 delay
time
A3 delay
time
Transmission
output 1 high
limit
Transmission
output 1 low
limit
Event input
function
A1 HOLD
function
A2 HOLD
function
A3 HOLD
function
Square root
function
Low level
cutoff
Returns to PV/SV display mode.
26
and
keys (in that order) together for
Maintenance mode
Returns to PV/SV display
mode.
+
(5 sec)
A1 output
ON/OFF
A2 output
ON/OFF
A3 output
ON/OFF
Trans.
output 1
manual
output