Sensor Identification - Siemens sitrans f Handbuch

Commissioning
4.2 Programming the Transmitter
Sensor Selection - Example for 1011 Universal Sensor
1. At the [Channel Setup] menu, press <Down Arrow>key to select [Install Xdcr].
2. Press <Right Arrow> key then <Down Arrow> key to [Transducer Model].
3. Press <Right Arrow> key.
4. Press <Down Arrow> key and scroll to [1011 Universal]. Press <ENTER> key to select.
5. Press <Down Arrow> key to select [Transducer Size].
6. Press <Right Arrow> key.
7. Press <Down Arrow> key and scroll to [B3]. Press <ENTER> to select.
8. IMPORTANT: Record Number Index and Spacing Method. Press <Down Arrow> key as
9. Sensors can now be mounted.
①
②

Sensor Identification

The sensor part number located on the front face provides a detailed identification. For
example, the Part Number:
①
②
③
④
26
needed to locate data.
Select based on type.
Select based on size.
Model
Hi Precision
NEMA w/F-Conn
Pipe Material
1011HNFS-D1H-UT1-S2 means:
⑤
⑥
⑦
Size
Temperature
Agency Approved
FST020 IP65 NEMA 4X
Operating Instructions, 07/2010, A5E03086489-01