Kickback And Related Warnings; Outdoor Use - Cocraft 40-9901 Bedienungsanleitung

i) Position the mains lead well away from the rotating accessory. If you lose
control, the lead can be sliced through or become entangled and pull your hand or
arm into the rotating accessory.
j) Never put the power tool down before the accessory has completely
stopped rotating. A rotating accessory can fasten on the work surface causing
you to lose control of the tool.
k) Never leave the power tool switched on while carrying it at your side.
Accidental contact with the rotating accessory could snag your clothing, pulling
the accessory into your body.
l) Clean the ventilation ports of the motor regularly. The fan of the motor draws dust
into the housing. A large build-up of metal dust particles can lead to electrical hazards.
m) Do not use the power tool near flammable material. Sparks can easily ignite
flammable material.
n) Do not use accessories, which require liquid coolants. The use of water or
other liquid coolants can result in electrocution or shock.

Kickback and related warnings

• Kickback is a sudden reaction to a wedged or stuck wheel, backing plate, brush,
or some other accessory. Pinching or snagging causes rapid stalling of the rotating
accessory which in turn results in the power tool thrusting violently in the opposite
direction of the accessory's rotation at the point of binding.
• Kickbacks are the result of the power tool being used in an incorrect manner, on
incorrect objects, or under incorrect conditions and can be avoided by observing
the following precautions.
a) Hold the power tool firmly and position your arms and body so that you
can resist kickback forces. Always use the auxiliary handle if there is one,
for maximum control over kickback or torque reaction during start-up.
The operator can control torque reactions or kickback forces, if proper precautions
are taken.
b) Never place your hand near the rotating accessory. The accessory can be
thrown back onto your hand.
c) Do not stand in the area, where the power tool is likely to end up if
a kickback were to occur. Kickback will propel the tool in the opposite direction
to the wheel's rotation at the point of snagging.
Outdoor use
• If the polisher is used outdoors, it is recommended that it is plugged into a socket
protected by a residual current device (RCD). The RCD should be rated to trip at
a current of 30 mA.
• Only use cables and connectors designed for outdoor use.
7