Before Use; Setting Up The Appliance; Inserting/Replacing The Soldering Tip; Operation - Parkside 275637 Originalbetriebsanleitung

Before use

Setting up the appliance

CAUTION!
► Never set up the appliance near easily
flammable materials (e.g. curtains, furnishing
fabrics, etc.). When using the illuminated
magnifying glass
soldering work, there may be a risk of fire.
Keep the entire appliance out of the reach
of children. Children could knock down the
appliance and be injured.
► Never cover the illuminated magnifying glass
while it is in operation.
► Never set up the appliance on an unstable
surface. If the appliance falls, it could cause
an injury.
♦ Remove the product from its packaging and
place it on a flat and level surface.
♦ Direct the illuminated magnifying glass
the gooseneck as required.
NOTE
► If the illuminated magnifying glass
switched off and not in use, place it in the
maximum vertical position.
│
■ 6 GB
in conjunction with
using
is

Inserting/replacing the soldering tip

CAUTION! RISK OF BURNS!
► Never heat the soldering iron
soldering tip .
■ The soldering tip may only be removed when
the appliance is switched off and the soldering
tip is cooled down.
■ The soldering tip has a screw thread and can
thus be removed quickly from the soldering iron.
♦ Unscrew the soldering tip anticlockwise.
♦ Screw the soldering tip in clockwise.

Operation

Switching the soldering iron on
and off
Switching on:
♦ Plug the mains plug
socket and press the On/off switch
"ON" position.
Switching off:
NOTE
► After use, always replace the soldering iron
in the soldering iron stand
♦ Press the On/Off switch
Always remove the plug
when not in use.
without a
into an appropriate wall
to the
.
to the "OFF" position.
from the socket
PLLL 16 A2