B) Activate Strobe Function; C) Sound-To-Light Mode; D) Permanent Light Mode; Master Mode - Renkforce DL-LED107S-UV Bedienungsanleitung

b) Activate strobe function

• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting SPee with the UP and DOWN buttons.
• Push the button ENTER. The display (oFF; SP1-SP8) flashes.
• Select the desired strobe speed SP1 -SP8 with the UP and DOWN buttons. The strobe function is oFF with this
setting.
• Confirm the setting with the button ENTER while the display is flashing.

c) Sound-to-Light mode

• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting SoUn with the UP and DOWN buttons.
• Push the button ENTER. The display SoUn flashes.
• Confirm the setting with the button ENTER while the display is flashing.
The effect light is now controlled via the installed microphone in time with the music.

d) Permanent Light Mode

• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting NASt with the UP and DOWN buttons.
• Push the button ENTER. The display NASt flashes.
• Confirm the setting with the button ENTER while the display is flashing.
The LEDs are permanently lit in this setting. If the strobe function has been activated additionally, the LEDs will flash
at the set speed.
e) Master Mode
• Set the desired operating mode (NASt, SoUn) at the master device in the ShNd menu.
• Then, use the button FUNC to select the setting SLNd.
• Push the ENTER button. The display flashes.
• Select the setting NASt with the UP and DOWN buttons.
• Confirm the setting with the button ENTER while the display is flashing.
The first device in the chain is set as the master unit. All further devices to be operated in the master-slave
chain are set as slave devices.
27