Use With An External Dmx Controller - Renkforce SC-12 Bedienungsanleitung

b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds. The
remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires one or seven free DMX channels depending on the operating mode.
Setting the DMX starting address
• Use the MENU (4) button to select Addr in the menu and push the ENTER (7) button.
• Select the desired starting address 1-512 with the UP (6) and DOWN (5) buttons.
• Press the ENTER button (7) to confirm your selection.
Setting the DMX channel number
• Use the MENU (4) button to select ChNd in the menu and push the ENTER (7) button.
• Select the desired DMX channel number (1 or 7) with the UP (6) and DOWN (5) buttons.
• Press the ENTER button (7) to confirm your selection.
Setting master-slave mode
• Use the MENU (4) button to select SLnd in the menu and push the ENTER (7) button.
• Select the desired DMX operating mode with the UP (6) and DOWN (5) buttons.
NASt Master mode (automatic mode)
SL 1 Normal slave mode (The device acts synchronously to the master)
SL 2 Inverted slave mode (The device acts inverted to the master)
• Press the ENTER button (7) to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a master device. The
device performs an automatically controlled light show in master mode.
Only one device in a master-slave-chain must be defined as master device. All other devices must be
defined as slave devices.
33