Dmx Connection; Connection Of A Dmx Controller - Renkforce SC-12 Bedienungsanleitung

• Secure the device with assembly equipment that is compatible with the attachment surface and suitable for carrying
the weight of the effect light.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The device includes a safety
eyelet to which you can easily attach the safety restraint cable. Screw this safety eyelet into the corresponding
thread at the bottom of the housing next to the mounting bracket. The safety retention rope or the net must be
designed to support the effect light in the event of failure of the main support system independently of the main
attachment.
• Set the desired inclination angle and tighten the thumb screws well.

9. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this case,
please use special DMX high-frequency cables.
a) Connection of a DMX controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the port DMX IN (13) with the output of the DMX controller.
• The controller must have 1 or 7 free control channels depending on operating mode.
• Connect DMX OUT (12) with the DMX input of the subsequent device.
• Proceed accordingly with all other devices of the DMX chain.
• If the effect light is the last or the only device in the DMX chain, insert an XLR plug with a 120 ohm/0.25 W
terminating resistor into the DMX OUT (12) socket (between Pin2 and Pin3).
29