Inserting The Bearing Capsule (Figure ) - RADEMACHER 2740 06 65 Original Montageanleitung Und Betriebsanleitung

Preparation for use of precision tubes (Figures
5.d
5.e
5.f
Inserting the bearing capsule (Figure )
1. Slide the bearing capsule (4) into the rotating union (5) and subsequently
place the ball bearing (2) onto the axle pin (3).
40
-
)
3. Slide the tubular motor into the precision tube.
4. Mark the four fastening holes and subsequently drill them through the
precision tube in the catch (8).
ATTENTION
◆ Never drill deeper than 10 mm into the catch (8).
◆ Never drill in the area of the drive. Doing so will cause serious
damage.
5. Screw or rivet the precision tube to the catch (8).
Use four self-tapping sheet metal screws or four pop rivets.
EN