Alarmbefehle - Magtrol DSP7000 Betriebsanleitung

Magtrol DSP7000-Leistungsbremsen-Controller
7.4.1 A
lArmBefehle
Command
Code
Channel 1-
ALA1,#
ALC,#
ALE1,#
ALL1,#
ALP1,xx.xx
ALS1,xx.xx
ALT1,xx.xx
ALW1,#
ALR1,#
GP, xx.xx
GT, xx.xx
Command
Code
Channel 2
ALA2,# Enables or disables air flow
alarm.
ALC,# Enables or disables clutch
alarm.
ALE2,# Enables or disables external
alarm.
ALL2,# Enables or disables all alarms. Values for # are:
ALP2,xx.xx Sets power alarm.
ALS2,xx.xx Sets speed alarm point.
ALT2,xx.xx Sets torque alarm point.
ALW2,# Enables or disables water flow
alarm.
ALR2,# Set up the Relay 1 on the IO
card, either channel one or two,
to be used in conjunction with
that channels alarm system.
See section 5.1.1 Alarm Relay
Set up the global power alarm
on WB/WB or PB/PB tandem
configuration.
Set up the global torque alarm
on WB/WB or PB/PB tandem
configuration.
71
Kapitel 7 – Rechnergesteuerter Betrieb
Function
Values for # are:
0 = disable
1 = enable
Values for # are:
0 = disable
1 = enable
Values for # are:
0 = disable
1 = enable
0 = disable
1 = enable
Sets maximum power in
kilowatts. Range is 0 to
99,999. Setting is applied to
current channel.
Sets maximum speed in rpm.
Range is 0 to 99,999. Setting
is applied to current channel.
Sets maximum torque in input
units. Range is 0 to 10,000.
Setting is applied to current
channel.
Values for # are:
0 = disable
1 = enable
Values for # are:
0 = disable
1 = enable
Set maximum global power in
Kilowatts. Range is from 0 to
99,999..
Set maximum global torque
in N·m.
99,999..
Explanation
Range is from 0 to