Timeout; Dsp7000 Command Set - Magtrol DSP7000 Betriebsanleitung

Kapitel 7 – Rechnergesteuerter Betrieb
7.3.2 t
imeout
Set the timeout for at least one second if asked to set a communication fault delay timeout.
Note:
7.4

DSP7000 COMMAND SET

When entering a command code:
1. Type all characters in uppercase ASCII format.
2. End all commands with a CR-LF (hex 0D-0A).
3. Do not string multiple commands together in one line.
The character # represents a floating-point numerical value following the command. Leading
zeroes are not required.
Note:
If the communication fault delay timeout is too short, or if the
computer resets the interface too quickly, the host instrument
may stop responding.
If a command is not recognized, the I/O ERROR message will
appear in the Status Display accompanied by a beep.
70
Magtrol DSP7000-Leistungsbremsen-Controller