Inhaltsverzeichnis
Werbung
Magtrol DSP7000-Leistungsbremsen-Controller
Number
23.
24.
25.
26.
27.
28.-35
2. Second the user used the OB command to retrieve the data. The data received from the
7.3
PROGRAMMING
7.3.1
d
AtA
7.3.1.1
Codes for CR - LF
Data
Quad_time_1
Quad_cnt_2
Quad_time_2
Display speed1
Display speed2
PA DATA (13)
Ob command is all the data acquired since the last OB command. The user must read
the data before 0.5 seconds elapses to avoid missing any data. The data can be read in
intervals as small as 50 ms to as long as 500 ms relieving the data acquisition system
from timing problems
Note:
The OB command is only applicable to the USB Configuration.
Note:
Check the manual provided with your software for full
instructions.
t
c
erminAtion
hArActerS
Use the following information to answer the formatting questions asked when installing
your GPIB software. All GPIB data acquisition systems require the use of data
termination characters. The DSP7000 uses the GPIB standard termination characters
Carriage Return (CR) and Line Feed (LF). Provide them in that order.
CR =
LF =
Kapitel 7 – Rechnergesteuerter Betrieb
Description
Quadrature position time 1
Quadrature position counter 2
Quadrature position time 2
Channel 1 display speed
Channel 2 display speed
Power analyzer data
EXAMPLE
COB,0,1,2,3
BASIC
HEX
CHR$(13)
0D
CHR$(10)
0A
69
Data Type
Integer
Integer
Integer
Float
Float
Not Defined
DEC
13
10
Werbung
Inhaltsverzeichnis
