Rechnergesteuerter Betrieb; About The Usb Interface; Usb Driver Setup For Windows Operation System - Magtrol DSP7000 Betriebsanleitung

7. Rechnergesteuerter Betrieb

The DSP7000 can be used with a computer to control a dynamometer and to transmit data from
the motor testing device directly to the computer. Using the DSP7000 with a computer enables
the unit to perform at its full capacity.
7.1

ABOUT THE USB INTERFACE

The USB interface is standard on the DSP7000. There is no need to set up. The USB interface
will be converted to a serial port in the PC. The USB driver must be installed in order for the
DSP7000 to communicate with the PC.
7.1.1 uSB d
river
Copy the dsp7000Vx.inf from the Magtrol website at www.magtrol.de/support/downloads.html
into local drive of your PC.
1. 1. Power on the DSP7000. A window in the right corner will show "Installing device
2. Click on the balloon depicted below will show which drivers did not install successfully.
3. If you have not installed one of these programs, this window will be displayed
S w
etup for indowS
driver software".
o S
perAtion yStem
61