Checking The Dsp7000-To-Pc Connection For Gpib Setup - Magtrol DSP7000 Betriebsanleitung

Kapitel 7 – Rechnergesteuerter Betrieb
12. This successfully installs the Virtual COM port drivers to your DSP7000.
7.1.2 c
hecking the
Note:
1. Make sure the primary GPIB address is set correctly for the DSP7000.
2. Set the input variable to 15 characters (13 variable characters and the two required data
termination characters CR and LF. See Section 7.3 – Programming.)
3. Issue output data command "OD" and read 15 characters according to the instructions
for your GPIB interface or serial.
Desired Results
•
•
Note:
dSp7000-t -pc c
o onnection for
Make sure that the DSP7000 and its host computer are
communicating before acquiring data.
Torque/speed data will be returned.
The error message I/O ERROR does not appear on the display panel.
If the desired results did not occur, please see Chapter 11 –
Troubleshooting.
Magtrol DSP7000-Leistungsbremsen-Controller
gpiB S
etup
66