Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Nordstrand • Trawler Yacht 21430
When you have got everything, familiarize yourself with the construction of „Nordstrand". This causes the least
bother, if you prepare the various parts for assembly at the same time: Remove the surplus material from the
vacuum moulded parts as shown in Figs. 1 and 2 on the following pages, cut out the apertures and eventually
remove the Small parts from the vacuum moulded as well as from the diecut ABS-, PVC- and plywood sheets.
Sand their outlines and then drill, saw and cut the following holes and apertures:
Hull 1
RC base plates 17
Engine mount 20
Cabin 32
Saloon 33
Wheel house 35
Awning deck 38 - four 1 mm dia. holes for eyebolts 121, twelve 2 mm dia. holes for
Wheel-house roof 43
Windlass casing 53
Flagstaff holder 63
Steps 65 and 79
Wheel console 87
Masthead fitting 92
Bathing platform 1o6
Thereafter, guided by the parts list, cut the total of 24 parts 19, 29, 30, 39 and 15 off the 5x5x500 mm pine strip.
While assembling your „Nordstrand", the various cements should be used as follows, if no other instructions are
given :
ABS-cement
Stabilit Express
CA-cement
To assemble your „Nordstrand" and to store and transport it later on, you can't do without a cradle, made up
from the two bearers A and B and the spacers C. The kit does not include the required material, but as thick-
ness and cross section are not critical, you will certainly find some suitable pieces of ply and strip wood in the
scrap box of your workshop.
02/2018
- one 4 mm dia. hole for rudder trunk 5,
- two 3 mm dia. holes each for screws 18 as well as apertures and
mounting holes to fit your RC equipmert,
- four 2 mm dia. holes for screws 24,
- four 2 mm dia. holes for handrails 110, sixteen 2 mm dia. holes for
handholds 108, two 3 mm dia. holes for vents 109, four window apertures,
- eight window apertures,
- five window apertures,
stanchion foots 122,
- one 2 mm dia. hole for foghorn 123,
- one 2 mm dia. hole for control lever 57, two 3 mm dia. holes for shaft 54,
- one 3 mm dia. hole for flagstaff 62,
- two 2 mm dia. holes each for handrails 64 and 72, Throttle lever
console 84 - one 1.5 mm dia. hole for throttle lever 85,
- one 3 mm dia. hole for wheel 88,
- two 1 mm dia. holes for shrouds 127,
- two 2 mm dia. holes for handrails 64.
- for engine mount, bulwark edges, fire-extinguishers, fenders,
ringbuoys and life raft,
- for rudder trunk, rudder and stern tube,
- for all other parts. Please note that CA-cement sticks best, if used as
sparingly as possible. Properly used, one 10 g bottle is ample to
cement all parts of this model.
3
Werbung
