Removing The Appliance From The Wall Bracket; Electrical Connection - clage MBX 3 Lumino Gebrauchs- Und Montageanleitung

7. Installing the appliance

Removing the appliance from the wall bracket

Put the wide screwdriver tip into the interlock between the water connections until it stops,
then press slightly upwards (1), tilt the appliance forward by max. 15° (2) and remove it
upwards (3).
8

8. Electrical connection

Only by a specialist!
Fill the appliance completely with water by repeatedly opening and closing the hot-
water tap before connecting to electrical power. The heating element may be damaged
if this is not done!
• Check that the power supply is switched off prior to electrical connection.
• The MBX 3 Lumino (3.5 kW) may be provided with a power cable and a protective earth
plug by the factory. Please make sure that the feed cable, which leads to the protective
earth plug socket, is dimensioned sufficient and that the socket is plugged to the conductor.
The socket must be freely accessible. The power cable needs to be changed by the customer
service department or an authorized electrician in case of defect, to avoid any danger.
• The mains cable of all other MBX Lumino models must be permanently connected via con-
necting box, as shown in the circuit diagram (see fig. 9). The earth conductor must be
connected.
• In accordance with IEC, a circuit breaker with a contact opening gap of at least 3 mm for
each pole must be provided on the mains side of the connecting box.
• The wiring cross-section must be well adapted to the corresponding power rating.
• To protect the appliance, a fuse element must be fitted with a tripping current commensu-
rate with the nominal current of the appliance.
25
CLAGE
EN