Rating Plate Cover - clage MBX 3 Lumino Gebrauchs- Und Montageanleitung

MBX 3..7 Lumino

11. Rating plate cover

11
EN
12
Removing the cover
The rating plate and the hood screw are located under this
cover.
1. Push the cover at the corrugation towards the wall bracket.
2. Press the cover down at the rear corners until the front
edge lifts.
3. Remove the cover by pulling forward.
Rating plate cover
On the inner part of
the cover, you can find
the name of the appli-
cation type (1), as well
as the serial number
(2) and the article
number (3).
Replacing the cover
1. Push the cover flat towards the wall bracket under the
edges of the water connections.
2. Press down the front edge of the cover and push it forward
again at the rear edge until it fits.
28
1
Gerät an Schutzleiter MBX 3-L
anschließen!
Appliance must be earthed!
CLAGE GmbH
21337
Lueneburg
GERMANY
2 3
1500-15203
012345-012345
MADE IN
GERMANY