Description Of The Appliance; Technical Specifications - clage S 10 Montageanleitung

S 10 / S 15

3. Description of the appliance

4. Technical specifications

Type
Order no.
Capacity
Energy efficiency class
Type of system (nom. pressure)
Inner container
Insulation
Nominal loading at 230 V
Nominal voltage 230 ~
Rated current at 230 V
Water connections
Mixed water capacity
1)
Temperature range
Temperature selection
Heating time for ∆t = 55 K
2)
Stand-by consumption 3)
Empty weight 4)
Type of protection acc. VDE
* ) The declaration complies with the EU regulation No 812/2013. The product data sheet is attached at the end of this document.
1) Mixed temperature 40 °C with hot temperature 65 °C and cold temperature 15 °C
2) Cold water temperature 10 °C
3) Stand by power consumption with 55 °C / 24 h
4) The water capacity should be added to the weight
The electric water storage heater S 10 / S 15 contains an inner copper container for sup-
plying hot water to one or more taps situated in close proximity to one another, e.g.
kitchen sink or two wash basins. The technical specifications are listed below.
The water storage heater can be installed as closed-outlet (with safety module) or as
open-outlet (with a suitable low-pressure fitting) device.
The appliance is designed for installation above or below the sink and must be
installed according to the type only.
The water in the boiler is heated to the temperature set on the appliance and then
stored.
S 10-U
42103
l 10
kW
V
A 10
inch ⅜
l 20
°C 5 - 80
min 17
kWh 0.34
kg 6,5
16
S 10-O S 15-U
41103 42153
10 15
A
Pressure type, 8 bar
Copper
Polyurethane
2,2
~ 230
10 10
½ ⅜
20 30
5 - 80 5 - 80
Control knob
17 26
0.30 0.49
6,5 7,5
IP 24
S 15-O
41153
15
B
10
½
30
5 - 80
26
0.43
7,5