Installing The Appliance - clage MBX 3 Lumino Gebrauchs- Und Montageanleitung

MBX 3..7 Lumino

7. Installing the appliance

5
EN
• Install the appliance with the water connectors vertically upwards for direct connection to
the sanitary tap.
• Secure the wall bracket to the wall with screws and suitable wall plugs (fig. 5).
• Place the appliance on the wall bracket and snap it into position (fig. 6). The appliance may
only be operated, when it has been properly placed into the wall bracket!
• Tap connection (fig. 7): Cold water inlet (blue) and hot water outlet (red) are marked on the
rating plate (under the rating plate cover).
• Connect the appropriate pipe or hose of the sanitary tap with the red marked hot water
outlet. Avoid exerting any kind of mechanical pressure exerted on the appliance, e.g. by
water pipes etc.
• After installation, carefully check all connections for leaks and rectify as necessary.
• In order to obtain an optimum water jet at low flow rates, always insert the enclosed
jet regulator into the sleeve of the tap outlet.
7
a
b
c
e
6
a. Seal
b. Strainer
c. Cold water-connection (inlet)
d. Hot water-connection (outlet)
e. Rating plate cover
a
d
24