LD Systems LDVIBZ24DC Bedienungsanleitung Seite 15

89 DFX PRESETS LIST
List of available digital effects.
90 DFX PEAK LED
Once the red Peak LED lights up, the input of the internal effects device is operating at the distortion limit. Adjust the Effect Send level controller DFX
SENDS AUX 4 (N 94) so that the peak LED does not light up when signal peaks occur.
91
DFX MUTE
In order to mute the internal effects device, briefly press the DFX Mute button once, and again to turn mute off. If the effects device is muted, the
peak LED N 90 lights up continuously.
92
SEND AUX 1 AND AUX 2
Volume controller for the sum signal from the input channels 1 to 23/24 routed via the AUX1 and AUX2 volume controllers.
93
SEND AUX 3
Volume controller for the sum signal from the input channels 1 to 23/24 routed via the AUX3 level controller.
94 SEND AUX 4 / DFX
Volume controller for the sum of the signals from the input channels 1 to 23/24 (external or internal effects device) routed via the AUX4 / DFX level
controller (N 10).
95 DFX TO AUX 1 AND AUX 2
Volume controller for adding the effects signal of the internal effects device to output channels AUX 1 and AUX 2.
DFX OUT
96
Volume controller for the volume of the effects signal at the DFX OUT output.
DFX TO MAIN
97
Volume controller for adding the effects signal of the internal effects device to the MAIN MIX sum channel.
98 OUTPUT LEVEL
2x 12-segment LED level display for visualising the level in the MAIN MIX stereo sum channel and for carrying out a more accurate adjustment of
gain since the volume level of the input signal is displayed on the LED level display when the PFL switch of the corresponding channel is pressed.
To avoid distortion, reduce the output volume of the MAIN MIX volume controller (N 110), or reduce the level of the input signal at the respective
GAIN controller as soon as the red CLIP LED lights up.
99 PFL-LED
The PFL lights up as soon as soon as one (or more) of the PFL switches of the input channels 1 to 23/24 is pressed down.
CTRL ROOM SOURCE MAIN / GR
100
Switcher for selecting the signal source for the signal output CTRL ROOM (N 10) and the headphone output (N 82). In the up position, the MAIN MIX
sum signal is present, in the down position, the group signal GR 1/2 or GR 3/4 is present (observe switch N 101 GR 1/2 / GR 3/4).
CTRL ROOM SOURCE GR1/2 / GR3/4
101
If the CTRL ROOM SOURCE MAIN / GR (N 100) switch is pressed down, either the group signal GR1/2, or GR3/4 can be selected can be selected as
signal source (switch not pressed down = GR1/2, switch pressed down = GR3/4)
102 CTRL ROOM LEVEL
Volume controller for the stereo line output CTRL ROOM (N 10). Before you turn on the power of the connected listening monitor, set the volume
controller to minimum.
15