Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The tempera-
ture control lamp (9)
does not light up.
No steam is pro-
duced.
Water emerges from
the bottom of the iron
(10).
Odour produced
Technical Data
Product numbers:
Model number:
Voltage supply:
Power:
Protection class:
Capacity of water reservoir: approx. 100 ml
23
Possible cause / solution
•
Is the mains plug pushed all the way into the plug socket?
•
Is the socket defective? Try another plug socket and check
the fuse of the mains connection.
•
Is the water reservoir (2) empty? Top up the water reser-
voir (2).
•
The device has not yet reached the operating temperature.
Wait until the temperature control lamp (9) goes out.
•
Is the temperature control (5) on a low temperature set-
ting? Select a higher temperature setting.
•
Is the regulator for steam (3) in position
steam generation.
•
At high temperatures the steam produced is dry and almost
invisible. This is exacerbated by a high ambient tempera-
ture. Switch the temperature control (5) to a lower tempera-
ture to check whether the device is producing steam.
•
Is the water reservoir (2) overfi lled? Pour away some water
(see the "Cleaning and Storage" section).
•
Is the temperature control (5) on a low temperature set-
ting? Select a higher temperature setting so that steam can
be generated.
•
You might notice a slight odour caused by production res-
idues the fi rst time you use the device. However, this is
harmless and will cease as you use the device.
00585 (blue)
00586 (red)
SW-1687-16
220– 240 V ~ 50 Hz
1600 W
I
Customer Service /
Importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls to German landlines are
subject to charges. The cost varies
depending on the service provider.)
All rights reserved.
EN
? Activate