Troubleshooting
If the device is not working properly, please check fi rst of all whether you are able to rectify a
problem yourself. Otherwise you should contact the customer service department. Do not at-
tempt to repair a defective device yourself!
Problem
The device does not
work. The operating
lamp does not light up/
fl ash.
No steam is produced.
Water emerges from
the bottom of the iron.
Smoke is emitted from
the device.
The device makes loud
pumping noises.
Technical Data
Model:
Article number:
Voltage supply:
Power:
Protection class:
Water reservoir capacity:
Possible cause/solution
•
Is the mains plug correctly inserted into the socket?
•
Is the plug socket defective? Try a different socket and check the
fuse of your mains connection.
•
Is the water reservoir fi lled with water?
•
The device has not yet reached operating temperature. Wait until
the temperature control lamp goes out.
•
Is the temperature control on a low temperature setting? Select
a higher temperature setting.
•
If you have set a high temperature, the steam which is generated
is dry and almost invisible. This is exacerbated by a high ambient
temperature. Switch the temperature control to a lower tem-
perature to check whether the device is producing steam.
•
Have you not moved the device for some time? The automatic
safety switch-off function was activated. Take hold of the handle
so that the device switches back on and heats up again.
•
Is the water reservoir overfi lled? Pour away some water (see the
"Use" chapter, "After Use" section).
•
Is the temperature control on a low temperature setting? Select
a higher temperature setting so that steam can be generated.
•
You might notice a small amount of smoke the fi rst time you use
the device. However, this is harmless and will cease as you use
the device.
•
Is the water reservoir empty? Refi ll it.
SG-8008S-8
Z 05560
220 – 240 V~ 50 Hz
2800 – 3200 W
I
approx. 400 ml
26