Use - Cleanmaxx 00585 Gebrauchsanleitung

EN

Use

ATTENTION!
■ Remove the mains plug from the plug socket after ironing or during lengthy breaks to
prevent personal injury or damage to property. Never leave the iron unattended while
it is connected to the mains power and keep children away from it.
■ Never attempt to iron clothes while somebody is wearing them.
■ Never aim the steam directly at people, animals or plants. This can cause severe
scalding.
■ You should only hold the device by the handle when you are operating it.
■ Always test the device fi rst on a small, inconspicuous spot on the clothing.
■ Be aware of damage caused by fi re! Never iron on one spot for too long. Never leave
the hot bottom of the iron standing on the fabric or another heat-sensitive surface!
■ Do not iron over zips, studs, clips etc. to prevent any scratching of the coating on the
bottom of the iron.
■ During and shortly after use, place the device on the base and on a fl at, stable and
heat-resistant and moisture-resistant surface.
NOTE: You might notice a slight odour the fi rst time you use the device. This is harmless
and will cease as you use the device.
Filling the Water Reservoir
ATTENTION!
■ Always remove the mains plug before you top up / empty the water reservoir. Never
pull the mains cable, but always pull the mains plug.
■ Never pour any additives into the water reservoir. This may destroy the device and
safe working is no longer guaranteed.
■ Never exceed the maximum fi ll level (note the max marking on the water reservoir!).
We recommend the use of distilled water to prevent possible limescale deposits.
The water reservoir (2) needs to be fi lled for steam-ironing or spraying. This is not nec-
essary for dry-ironing.
Heating Up the Iron
1. Check the label in the garment for the required ironing temperature (see the "Ironing
Recommendations" chapter) and set this temperature using the temperature con-
trol (5).
1. Make sure that the device is not connected to the mains
power. Move the regulator for steam (3) to position
(steam off) and the temperature control (5) to position MIN
(turn MIN to marking (A)).
2. Fill the water reservoir (2) up to the max marking with tap
A
water or distilled water. It holds approx. 100 ml.
20