Self-Cleaning Function; Troubleshooting - Cleanmaxx Z01211 Gebrauchsanleitung

Self-Cleaning Function

CAUTION!
■ Danger of scalding! Hot water and steam will emerge from the bottom of the iron dur-
ing the self-cleaning process. Keep the bottom of the iron away from all body parts
and delicate materials when you press the self-cleaning button!
■ Only ever press the self-cleaning button to perform self-cleaning and not during
ironing!
The device has a self-cleaning function allowing limescale residues to be removed from
the device. Additional descaling of the device is not necessary. Perform the working
steps which are described below regularly (at least every 10 operating hours):
1. Fill the water reservoir (6) up to the max marking with tap water (see the "Use" chap-
ter, "Filling the Water Reservoir" section).
2. Place the device on an even, stable and heat-resistant surface.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Heat the device up to the highest temperature setting.
5. Hold the device horizontally over a sink or similar outlet.
9. If you need to, operate the device again for a short time in order to allow any remain-
ing amounts of water to evaporate.

Troubleshooting

If the device should stop working properly, fi rst check whether you are able to correct
the problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The tempera-
ture control lamp
does not light up.
25
6. Press the self-cleaning button (15).
7. Allow the water reservoir (6) to run completely empty. Tilt
the device back and forth slightly to allow the water to run
out of all nozzles.
8. Repeat the cleaning process several times until no more
limescale residues emerge from the nozzles.
Possible cause/solution
• Is the device connected to the adapter correctly and is the
mains plug pushed all the way into the plug socket?
• Is the plug socket defective? Try a different socket and
check the fuse of your mains connection.
EN