Resetting To Factory Status; Device Led Feedback Messages; Flash Codes - HomeMatic HM-LC-Sw1-SM, HM-LC-Sw4-SM Installations- Und Bedienungsanleitung

9

Resetting to factory status

In order to reset the actuator to factory status, switch
the device to teach mode with the (first) channel
button (hold button pressed for at least 4 seconds).
If the device is in teach mode, hold the (first)
channel button pressed down for at least 4 seconds.
The actuator reset is indicated by the device LED
flashing quickly.

10 Device LED feedback messages

10.1 Flash codes

Different actuator states are indicated by the
channel LED/channel LEDs flashing:
Slow flashing
Fast flashing
One long, x-short
(depends on the type
of error)
50
Teach mode
Reset
Error